• Satinwood 28 Base is recommended for Hardwoods of low porosity.
• Satinwood 28 is recommended for Softwoods and Hardwoods of high porosity.

1. RECOMMENDED PRETREATMENT AT FACTORY LEVEL

• Completely submerse individual and/or glue-assembled components into Satinwood 28/28 Base for at least 30 to 60 seconds.
• Remove and allow excess liquid to drain back into dip/immersion tank.
• Allow Satinwood 28/28 Base to absorb into the wood for at least 30 minutes.
• Use a clean cotton cloth and wipe off all excess liquid to leave a natural smooth finish.
• Allow to dry for approximately 24 hours, depending on prevailing conditions, before assembly and/or packaging.
  
  IMPORTANT
  
• Mix Satinwood 28/28 Base well before addition to dip/immersion tank.
• Always mix contents of dip/immersion tank before use and at regular intervals during use, as and when required.
  
  Note: Supply or sell a sufficient volume of Satinwood 28/28 Base with the finished goods for the application of at least two further coats.

• Apply two coats of Satinwood 28/28 Base prior to utilizing the furniture outdoors. (See recommended application procedure below)
• Ensure that all end grain is thoroughly coated/sealed.
  

• Depending on outdoor conditions, apply one coat of Satinwood 28/28 Base at least twice a year (See recommended application procedure below).
• When in doubt, apply Satinwood 28/28 Base when the wood appears faded or dry, especially on the horizontal surfaces.
  

• Wipe surface down with a clean cotton cloth lightly moistened with mineral turpentine. (Ensure that all surfaces are completely dry and clean before proceeding with the next step)
• Use a clean cotton cloth dipped in the Satinwood 28/28 Base and apply in light, short strokes, ensuring thorough and even distribution of the sealer.
• Leave the sealer on the furniture for at least 30 to 60 minutes (but not more than 24 hours), to allow absorption into the wood.
• Use a clean cotton cloth and wipe off all excess liquid to leave a natural smooth finish.


• Allow to dry for approximately 24 hours before application of another coat or before use.

• Satinwood 28/28 Base is a ready for use formulation. Do not dilute.
• Mix well before use.
• Never apply Satinwood 28/28 Base on wet surfaces or during the heat of day, except if shaded from direct sunlight.
• If applied by brush, roller brush or spray methods, clean equipment with mineral turpentine after use.
• Regular application of Satinwood 28/28 Base will ensure that your outdoor wooden furniture remains fully protected against our harsh South African climatic conditions.

• Flammable liquid - Avoid open flames during use.
• Avoid eye splashes and prolonged skin contact.
• Used cloths may ignite spontaneously - Dispose of in a safe manner or completely submerse in water after use.